Although I haven't read the book for a long time, the desk lamp is still there. Some time ago, I saw foreign netizens making a lamp with a sense of design. I wanted to share his production experience. He made a spiral table lamp.
The desk lamp is mainly composed of wooden pins, each of which is about 7cm (2.75 inches) in length and 5mm (0.19 inches) in diameter. Therefore, the table lamp made this time is very small. Of course, if you want to make the size bigger, you need a bigger one. Wooden pin. If there is no wooden pin at hand, you can replace it with a cardboard tube. See the second step for the specific production process.
In short, it is recommended to use LED tubes, at least energy-saving lamps, especially cold light.
The first step: the required equipment
124 wood pins - (can be bought on a treasure)
Hot melt adhesive
cardboard
ruler
pencil
Light bulb and lamp holder
The hot melt is chosen because it does work very quickly. If you want the desk lamp to have better insulation, it will be better with white glue.
Step 2: Assembling the wooden pin
As shown in the figure, four wooden pins are used to form a square, and each wooden pin forms an edge. Since the ends of the wood pin are round: the sol method of the above figure is used. By analogy, 31 squares of the same size were made.
We provide quick-turn injection molding by many types of materials, like ABS, PA66, PBT, TPU, TPE, PVC, PE, NYLON 6, PC, silicone, TPE, EPDM, PUR, etc. Special for some plastic parts. Our advantages in internal prototyping, bridge tooling and short-run manufacturing, which can eliminate the costly and time-consuming for customers a lot.
After customer approved 3D drawing, we can test it by 3D printer first, then move on for formal tooling once confirmed ok. And all related materials, logo, color or finishes can be chosed as customers' requirement.
Injection Molding Parts,Plastic Injection Molding,Low Cost Plastic Injection Molding,Plastic Mold Injection Molding
ETOP WIREHARNESS LIMITED , https://www.etopwireharness.com